Builders:
We got word from one of our Canadian builders in Northern Ontario that he is unable to continue with his airplane and 3 Liter Corvair project. He is selling the engine parts below, which is a very good start on a 3,000 cc engine. It still needs the heads done, (but cores have already been shipped to Falcon), it needs an Oil system, a starter a distributor and some small items. The total spent below is about $6,500US, the builder is looking for a quick sale at equivalent of $5,000US. I have met the man in person and can verify that all the items below are from us and the Wesemans.
.
This is a good opportunity for a Canadian builder to get a strong running start, because the parts are already past the point of import tax, but the sale offer is open to any builder on either side of the border.
.
The owner of the project is Trevor Leslie he can be contacted directly at his email address:
trevorleslie@hotmail.com
.
“Engine has been assembled to the short block stage.
The asking price DOES NOT include rebuilding of the heads!”
-
Original block which is from a 67’ (T0326RH) Machined to accept 3000CC cylinders
-
Original Crank GM 8409 prepped by Dan Weseman with Gen 2 5th bearing
-
New Federal Mogul main bearings (0.10) and connecting rod bearings (0.10)
-
New OT-10 Cam with thrust washer, key and “fail-safe” cam gear.
-
New Sealed Power HT-817 hydraulic lifters
-
New Piston set with wrist pins, ring set and connecting rods
-
Flycorvair.com 3000CC kit, pistons cyls. rods
-
New powder coated pushrod tubes(flycorvair.com)
-
Short gold hub (flycorvair.com 2501(B))
-
Hybrid studs (2502)
-
Safety Shaft (2503)
-
Modified ring gear (2408)
-
Oil Cooler Block Off kit
.
